KDWPT / Fishing / Hatcheries / Milford / Milford Hatchery Setup



Milford Hatchery Setup

RACEWAYS

Each of the 24 concrete raceways holds approximately 18,000 gallons of water and measures 100 feet long, eight feet wide and four feet deep. Depending on the size of fish, a raceway can hold between 35,000 and 150,000 fish weighing 2,000 to 8,000 lbs.

The water source for the hatchery is a combination of well and lake water. During the winter, the water is a constant 58º F since it is taken from wells. The three wells have a combined pumping capacity of 2,500 gallons per minute. Water is taken from the outlet lake south of the. hatchery when the water temperature in the lake has stabilized at or above 60-70ºF.

The large brown hoppers, called demand feeders, contain specially-formulated fish food. The catfish learn to hit a rod that releases the food. The hatchery also uses automatic solar and belt feeders to dispense formulated feed to other fish species.

Each raceway has its own recirculation system in which about one-third of the water is recycled. The water in the raceway is completely exchanged every hour in the summer. Additional oxygen is added to the reaceqays with liquid oxygen by injection into white chambers at the head of each raceway.

The partitions you may see in the raceways do not extend to the bottom, so fish can freely travel up and down the length of the raceway. These baffles help to create a higher water velocity near the bottom to sweep it clean of debris.

AERATION TOWERS

All incoming water is aerated by the red towers at the south side of the raceways. Each tower contains a series of aluminum baffles over which water cascades. This allows for oxygen to be added before water is delivered to the raceways.

HATCHERY BUILDING

The large hatchery building holds fish incubation and start tank equipment, electrical monitoring and control equipment, water filtering equipment, a lab, offices, and a shop area.

MECHANICAL ROOM

The mechanical room houses three large sand filters that clean the water used inside for hatching and growing fry. Milford egg hatching

INCUBATION ROOM

The incubation room consists of four hatching racks, a spawn area, and 16 large catch tanks. Hatching of walleye eggs normally begins in late March and finishes by early May. Eggs are stripped from the females and fertilized in a pan with milt (sperm) taken from the male. The fertilized eggs are then placed in a special plexiglass hatching jar. Water is constantly circulated through the jar to provide oxygen to the eggs. In approximately 10 days, the eggs hatch and the fry, which swim to the top, are swept into catch tanks. When the fry are three to four days old, most are stocked in lakes and reservoirs.

Each hatching jar can hold approximately 300,000 eggs. The maximum capacity for the incubation room is 120 million eggs.

START TANK ROOM

Fish received at the hatchery as fry or fingerlings must be trained to eat pelleted food. When the fish arrive, they are placed in the fiberglass start tanks. Automatic feeder are used to introduce feed every 10-20 minutes around the clock. When the fish are about three inches long and accepted the formulated feed, they are transferred to the raceways.